In this guide, you will get to know How to Breed Villagers in Minecraft PE. It is a little difficult to breed villagers in Minecraft PE, follow the steps in this guide to do so.
First, you have to make a new house, install the iron gate to that house and inside that house, you need to have three beds. Then place three composters to the side of each bed, as shown in the image below.
And now you have to bring the two villagers to the house, and you will need a boat for that. Make sure that you have built the house near the village because the villagers do not travel easily.
You have to find a villager and place the boat near him, as shown in the image below.
When you place the boat near him, he will sit on the boat, and next, you have to drive the boat to the house. On the way, you will see that the ground is above your boat; you will need to place the piston in that position and attach a lever with it. Place your boat on that piston, and then push the lever and it will go up and get you to the higher ground.
And now, you can make your way to the house.
After reaching the house, you have to push the button and open the gate. Enter into the house and place the boat near the bed, as shown in the image below.
Now you have to go to the boat and remove it very carefully because if you don’t, it might hurt the villager and he might die. After removing the boat, you have to break the bed and replace it with the new one so that the villager will interact with it.
Now you have to go back again and bring the second villager into the house, in the same way, using a boat.
Next, you have to feed them bread or whatever you want, but bread is the best thing for breeding. You will need to collect the bread, select the bread from the hot bar, then hold it for a while, and it will be automatically thrown to the floor, and then the villager will pick that up.
Feed the bread to both of the villagers. During this process, you will find that they will start the process for the breeding, as shown in the image below.
You have to make sure that they focus on each other during the process, and you don’t have to disturb them at all. After few minutes, the baby will appear, as you can see in the image below.
